Accessing The Internal Components Of The Computer - HP Z210 Installation Manual

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and
replacement procedures in the service guide for your computer at
manuals.
2. Power down the computer, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the computer.
4. Remove the side access panel.
Step 2—Installing the DX115 case into the optical drive
bay
See the steps for the applicable computer model in the following sections.
CAUTION:
Other procedures may result in system hangs, data loss, or even drive damage. The component
supplier's user guide describes a procedure for inserting or removing the carrier (with drive) while the
workstation is booted and then powering the drive via the power switch on the enclosure. Microsoft
Windows XP and Windows Vista do not support this action.
NOTE: The CRU Dataport DX115 does not fit in all optical drive bays. It is longer than most optical
drives. Choose the optical bay for the CRU Dataport DX115 which best fits your computer
configuration.
CAUTION:
proper connection, remove the adapter before continuing with installation, as shown in the figure
below.
ENWW
Insert or remove the carrier (with a disk drive) only when the workstation is shut down.
HP computer SAS disk drives are configured with a SAS to SATA adapter. To ensure
Step 2—Installing the DX115 case into the optical drive bay
http://www.hp.com/support/
3