Locating Internal Components; Removing And Replacing The Battery - HP t628 Troubleshooting Manual

Locating internal components

Item Component
1 M.2 socket shown with Wi-Fi module installed
2 Front I/O board
3 Hard drive bracket
4 Primary storage slot shown with flash memory
storage installed

Removing and replacing the battery

WARNING!
disconnected from the AC outlet.
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external devices.
4. Unplug the power cord from the AC outlet, and disconnect any external devices.
CAUTION:
the system is plugged into an active AC outlet. You must unplug the power cord to avoid damage to the
internal components of the thin client.
5. Remove the stand from the thin client.
6. Position the unit flat on a stable surface with the right side up.
7. Remove the thin client access panel. See
8. Locate the battery on the system board. See
Before removing the access panel, be sure that the thin client is turned off and the power cord is
Regardless of the power-on state, voltage is always present on the system board as long as
Item Component
5 Configurable serial port jumpers
6 Memory module
7 Battery
8 CMOS button
Removing and replacing the access panel on page
Locating internal components on page
9.
11.
Locating internal components 11