HP Z210 Installation Manual page 13

4. Install one (supplied) 6-32 x 1/4 in. screw (silver) for each DX115 unit for shipping support.
CAUTION:
drive system.
Figure 21
HP Z600 and Z800 computers
1. For HP Z800 computers:
●
Remove the airflow guide to enable access to the optical bays.
●
Remove the card support to enable access to the system board connectors.
2. Remove and discard the counter-sunk shipping screw at the side of the DX115 case.
Figure 22
3. Lift and hold the drive release latch at the green touch point (1) while sliding the DX115 case into
the bay (2). When the front of the drive is near its final position, release the latch, but continue to
slide the drive inward until the latch closes and engages the drive.
Figure 23
ENWW
Failure to install the shipping screw might result in damage to the removable hard
Installing the shipping support screw
Removing the shipping screw
Installing the DX115 case
Step 2—Installing the DX115 case into the optical drive bay
13