HP Z210 Installation Manual page 19

3. Connect the opposite end of the data cable to the appropriate connector on the system board or
controller card.
●
Connect SATA drives to SATA ports, and SAS drives to SAS ports, starting with the lowest-
numbered available port.
●
For HP Z400 and Z600 computers, the blind-mate cables for the internal hard drive bays
may require adjustment at the system board, based on the computer drive configuration.
Consult the User Guide or the Maintenance and Service Guide for your computer for
additional information.
4. To prepare your installed hard drive for operation, see the appropriate hard drive documentation.
5. Replace the computer bezel and bezel security screw, if applicable.
6. Reinstall the card support, if applicable.
7. Reinstall the airflow guide, if applicable.
8. Reinstall the side access panel.
9. Reconnect all external devices.
10. Restore power to the computer and all external devices.
ENWW
Step 4—Completing the computer assembly
19