Accessing The Internal Components Of The Computer - HP Z Turbo Drive Quad Pro Installation Manual

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and replacement
procedures in the HP Customer Self Repair Services Media Library at
service guide for your computer at http://www.hp.com/support/manuals.
2. Power down the workstation, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the workstation.
4. Remove the access panel by lifting up on the release latch and raising the panel from the chassis.
Installing the drive in an HP Z440 Workstation
If more than one of any of the following drives are to be installed in a system, a unique address for each drive
must be configured before installation:
● HP Z Turbo Drive
● HP Z Turbo Drive G2
HP Z Turbo Quad Pro
●
For configuration instructions, see
on page 14.
1. Press down on the two green PCI retention clips (1) located inside the workstation until they release,
and then rotate them down to raise the retention clamp (2).
8 HP Z Turbo Drive Quad Pro installation
Installing multiple HP Z Turbo Drives or HP Z Turbo Quad Pro Drives
http://www.hp.com/go/sml or in the