Setup Procedure - HP Z1 User Manual

Setup procedure

1.
Read the following warnings. It is your responsibility to understand and comply with them.
WARNING!
workstation, have someone help you remove it from the box.
WARNING!
— Plug the power cord into an easily accessible, grounded (earthed) three-pin outlet.
— Do not disable the power cord grounding pin (for example, by attaching a two-pin adapter). It
is an important safety feature.
— To disconnect power from the workstation, unplug the power cord from the AC outlet.
2.
Carefully remove the workstation from the box and place it on a sturdy, level surface. Remove all
plastic packaging.
3. Push down firmly on the workstation to unload the latch in the stand.
Figure 3-1
4.
With one hand, grasp the bottom edge of workstation in a way that allows you to press the green
button on the stand (1). Grasp the handle at the top of the workstation with your other hand (2).
Push the green button and hold it in while you raise the workstation to its maximum horizontal
height (3).
Figure 3-2
NOTE:
some force to raise the workstation.
The workstation weighs 21.3 kg (47.0 lbs). If you cannot safely lift the
To reduce the risk of electric shock or damage to your equipment:
Unload the latch
Raise workstation
Because the workstation is heavy and the stand joints are tight, you may need to exert
Setting up the workstation
11