HP Z1 User Manual page 25

4.
Install the receiver in the internal USB port on the rear I/O assembly.
Figure 3-12 Install receiver
NOTE: An outline around the internal USB port identifies the maximum area allowed for an
internal USB device. The receiver must fit within this area.
5. Close the workstation and maneuver it to an upright position. Plug in the power cord and turn on
the workstation.
6. Turn on the power on the bottom of the wireless mouse (1) and remove the battery tab on the
bottom of the wireless keyboard. Make sure the mouse and keyboard are within 30 cm (12 in) of
the workstation and away from interference from other devices. Press the connect button on the
mouse (2) for five seconds, then press the connect button on the keyboard (3) for five seconds.
Place them in front of the workstation.
Figure 3-13
Activate wireless keyboard and mouse
Setting up the workstation
17