HP Vectra XU 5/XX Introduction Manual page 59

If the PC failed part of its Power-On Self-Test (POST) and the indicator light next to the
power switch displays RED, you should take one of the following actions:
Press [ ] to display information about the error and follow the suggested
ENTER
corrective action.
Press [F2] to run SETUP and correct the System Configuration error. (Refer to
"Configuring Your PC" for information on using SETUP.)
Press [F1] to continue and ignore the error. (It is recommended that you fix the error
before proceeding, even if the PC appears to start successfully.)
Corrective actions for POST error messages are described in the following table.
POST errors that may prevent the PC from starting
Error No. Corrective Actions
0130 The capacitor has discharged as the PC has been unplugged from the
power outlet for three days or more. Run SETUP and enter the time and
date. If this happens every time you start your PC, contact your authorized
HP service representative.
0240, 0250 1. Ensure the configuration stored in EEPROM has not been cleared by
0811, 8x03
8060, A001
2. If the hardware has been changed, run SETUP to update the
3. If the problem persists, contact your authorized HP service
0801 1. If you don't start (boot) your PC remotely, run SETUP. Set `Remote
2. If the `Remote Start' field is set to `None' in SETUP, initialize the system
3. If the problem persists, contact your authorized HP service
61xx, 6500 1. Ensure the memory modules are installed correctly. (Refer to "Installin g
6510, 6520
2. If this fails to correct the problem, initialize the system ROM as described
3. If the problem persists, contact your authorized HP service
65Cx, 65Dx 1. Disable all shadowing in SETUP. (Refer to "Configuring Your PC" for
66xx
2. If this fails to correct the problem, contact your authorized HP service
If the POST is not in Your Language
If the POST screen is not in your local language when you switch ON the PC, initialize the
system ROM, as described earlier in this chapter.
HP Vectra XU PC – Setting Up
system board switch CONFG being set to ON (refer to "Troubleshooting
and Error Messages" for details).
configuration information. Note that SETUP automatically fixes most
errors.
representative.
Start' to `None' and set `Protocol' to `Not Used'. (Refer to "Configuring
Your PC" for details.)
ROM as described earlier in this chapter.
representative.
Accessories" for details.)
earlier in this chapter.
representative.
details.)
representative.
Troubleshooting and Error Messages 59