HP Vectra XU 5/XX Introduction Manual page 37

Configuring Your PC
Overview
This chapter explains how to configure the PC using SETUP.
SETUP is an integrated program stored in ROM, used to tell the PC about items installed in
it. Use SETUP to view or change the following settings:
Date and Time
User Preferences
Processor Information
Main Memory
SCSI and IDE Drives Interface
Flexible Disk Drives
Security Features (including System Administrator Password)
Parallel and Serial Ports
Network
Video Modes
IRQ Map for Accessory Boards
BIOS Version.
SETUP has three types of entries:
entries filled automatically when the PC detects hardware, during the Power-On Self-
Test (POST)
entries providing information only, which cannot be changed
entries you can set to your own values (for example, passwords).
NOTE If you can't change the PC's configuration in SETUP:
The System Administrator Password is set, "locking" all SETUP entries except
Date, Time, and User Preferences.
You didn't enter the correct password when you started SETUP.
System board switch SECUR is ON, protecting the configuration. (Refer to
"Troubleshooting and Error Messages" for details.)
HP Vectra XU PC – Setting Up Configuring Your PC 37