HP Vectra XU 5/XX Introduction Manual page 42

On a PC with one flexible disk drive, Drive 1 (the top drive) will be set to 3.5 inch, 1.44
MB, and Drive 2 set to None.
If you have installed an optional flexible disk drive that uses the integrated disk interface,
ensure that SETUP has detected the drive. If you have installed an optional flexible disk
drive that has its own controller board, set the Interface field to Controller Board.
Configure the controller board as described in its manual.
If you have two flexible disk drives, set one as the Bootable Drive. This is the drive the
PC uses to start (boot) from a system diskette.
Configuring SCSI Hard Disk Drives
If you have installed an optional SCSI hard disk drive, configure it in SETUP.
To configure an IDE hard disk drive:
1. If your PC has no IDE hard disk drives, in the "IDE Hard Disk Drives Interface" section,
both the Drive 1 and Drive 2 fields will be set to None or SCSI.
2. If your PC has one IDE hard disk drive already installed, check that the Drive 1 field is
set to Configured and the Drive 2 field is set to None or SCSI.
3. In the Integrated SCSI Interface group, check the Integrated Interface
field is set to Enabled.
4. Highlight the SCSI BIOS field, and check it is set to Enabled.
Configuring IDE Hard Disk Drives
If you have installed an IDE hard disk drive, configure it in SETUP.
To configure an IDE hard disk drive:
1. A primary drive (Drive 1) uses the long IDE cable; a secondary drive (Drive 2) uses the
short IDE cable. Check the corresponding Drive 1 or Drive 2 field is set to
Configured.
HP Vectra XU PC – Setting Up Configuring Your PC 42