HP Vectra XU 5/XX Introduction Manual page 46

Configuring the Network Interface
The PCI integrated Ethernet interface configures itself automatically. SETUP allows you to:
Enable or disable Remote Start, and select the protocol used.
Enable (default) or disable the PCI integrated Ethernet interface.
View the MAC address, if the adapter was previously enabled.
When the integrated interface field is set to Disabled, the MAC Address field is set to
Not Used.
Enable or disable Start With Keyboard Locked .
The LAN Administrator Guide supplied with the PC contains step-by-step information on
configuring the network.
You will need to ask the Network Administrator to install network drivers and configure the
network so it will work with the PC.
NOTE Under certain circumstances you may be asked to insert a LAN Driver diskette in
drive A.
In this case, you should either use the LAN driver diskette which you created with
the Master Diskette Creation Utility, or you should type
C:MASTERS\LANDRV\DISK1
Enabling Remote Program Load
The Remote Program Load group of fields enable the PC to start from a server.
The Remote Start field allows you either to disable Remote Program Load or to select
the type of network your PC is connected to. When Remote Start is enabled, you must
disable Starting From Hard Disk described in Configuring the Security Features
earlier in this chapter.
The Protocol field tells the PC which network operating system is used. (It is automatically
set to Not Used if Remote Start is Disabled.)
To enable remote program load:
1. Highlight the
Remote Start
None.
2. Highlight the
Protocol
system.
HP Vectra XU PC – Setting Up
.
field, and press [
field, and press [ ] or [
F7
Configuring Your PC
] or [ ] to set it to either Ethernet or
F7 F8
] to display the network operating
F8
46