HP Vectra XU 5/XX Introduction Manual page 17

5. Rotate the drive into position and secure it with the captive screw.
6. Install any other accessories before replacing the cover. Then run SETUP. (Refer to
Completing the Installation Procedure.)
7. Format this hard disk and then install the operating system, if required. Install any
software drivers needed for the device, and then any other applications. (Refer to
Completing the Installation Procedure.)
Installing a Hard Disk Drive in the Bottom Shelf
Your PC has an integrated Fast SCSI-2 controller for SCSI drives, and an integrated
Enhanced IDE controller for IDE drives.
For other devices, you may need to install a controller board. Refer to the device's manual
for any special installation procedure.
HP Vectra XU PC – Setting Up Installing Accessories 17