HP Vectra XU 5/XX Introduction Manual page 22

supply while you are removing the accessory from the bag. Handle the
accessory as little as possible and with care.
To install main memory modules:
1. Remove the PC's cover and power supply, as described earlier in this chapter.
2. Memory modules can be installed up to a maximum of 256 MB. They must be installed
in pairs of the same capacity, beginning with bank A, up to bank D.
3. Align the main memory module directly over the socket, with the "cutout" towards the
outside of the PC. Slide the memory module into the socket at 45°. Firmly press the
memory module completely into the socket.
4. Pivot the memory module to the vertical position.
5. Repeat this procedure for the other memory modules.
6. Install any other accessories before replacing the power supply and cover. Then run
SETUP. (Refer to "Configuring Your PC".)
If you need to remove a main memory module
HP Vectra XU PC – Setting Up Installing Accessories 22