Phase 2 - Install Hp Drivers - HP Tc2100 - Server - 128 MB RAM Installation Manual

Chapter 4
For Small Business Suite 5.1
1. A graphic interface will display. Select your language then click Next.
2. When prompted about the DOS Partition, select "Create a new DOS
partition" then click Next. hp recommends you keep the default
partition size. Click Yes to any warnings. Click Next at the summary screen
to reboot and continue the installation.
3. At the Install Type screen, select "Advanced Installation" then click
Next. Click Next at the summary screen to continue the installation.
4. Insert your NetWare Small Business Suite 5.1 License diskette and press
Enter. The system will proceed with Novell installation. Press F10 to accept
the License Agreement.
For both NetWare 5.1 and Small Business Suite 5/5.1
5. Press Enter to setup "a new server" then scroll down and choose
Continue.
6. Modify or accept the server settings, the regional settings, as well as the
mouse and video configuration.
PHASE 2 – Install HP Drivers
1. The installation program then detect your hardware and attempt to match the
drivers to the hardware. It displays a driver summary screen.
2. If you have an IDE system, press Enter to continue. If you have a SCSI
model, you need to install the HP SCSI driver (the SCSI driver proposed by
default by NetWare does not install properly):
a. Scroll down to chose Modify and press Enter.
b. Scroll down to highlight the "Storage Adapters" item and press
Enter.
c. The installation program displays the drivers detected: a SCSI driver and
a generic ATA/IDE/ATAPI Adapter driver (IDEATA.HAM). Press Delete
to remove the default SCSI driver. The only remaining driver should be
the IDEATA.HAM driver.
NOTE Do NOT remove the IDEATA driver because it is used by the
CD-ROM Drive.
d. Insert HP disk NW#1 (created with the Startup CD) in the floppy drive.
Installing Novell NetWare 5.1 and Novell Small Business Suite 5.1
37