Phase 7 - Install Hp Video Driver; Section 4. Initialize Hard Disk Drive - HP Tc2100 - Server - 128 MB RAM Installation Manual

Chapter 2
PHASE 7 – Install HP Video Driver
The Microsoft Windows installation process has installed the standard VGA video
driver. If you would like to make use of the high-resolution video driver, follow
these steps:
1. Ensure Microsoft Windows NT Service Pack (version #6a or above) is
installed. This is a REQUIREMENT.
2. Logon as the Administrator on your HP server then insert HP Startup CD in
the CD-ROM drive. The Startup CD will automatically start and a menu will
display.
NOTE Your HP server should auto-detect the presence of the Startup
CD and start the Startup menu. If your HP server does not
auto-start the Startup menu, start it by opening Startup.htm
which can be found at the root level of the Startup CD.
3. Select "Automated installation of hp video driver for
Microsoft Windows NT Server".
4. The HP video driver (ATI video) setup program will open. Click Next to
start the installation then click Yes to accept the License Agreement.
5. Click Finish when prompted to restart your system at the end of the
installation.
6. After your logon, you will be notified that default display resolutions are
being used. Click OK. You can now configure your settings and test them.

Section 4. Initialize Hard disk Drive

To manage your different drives and partitions:
1. Click Start | Programs | Administrative Tools | Disk Administrator.
2. Click OK to proceed when notified you have a new hard disk to configure.
3. Select available hard disk space on the graphic and use menus to create
additional partitions.
4. Exit the Disk Administrator.
5. To complete formatting of new partitions, open My Computer, right click
on a new partition(s) to be formatted and select format.
10
Installing Microsoft Windows NT 4.0 Server