Phase 4 - Adding Terminal Server Services - HP Tc2100 - Server - 128 MB RAM Installation Manual

Chapter 3 Installing Microsoft Windows 2000 Server and Small Business Server 2000

PHASE 4 - Adding Terminal Server Services

1. Open Start | Settings | Control Panel | Add Remove Programs.
2. Click "Add/Remove Windows Components".
3. Scroll to and click "Terminal Services" checkbox then click Next.
4. Select the mode you want to use: "Remote administration mode"
or "Application sever mode" then click Next.
NOTE
5. Select the default permissions for application compatibility then click Next.
6. Click Next to accept support tools and administrator tools settings.
7. If prompted, insert the Windows 2000 CD-ROM.
8. Click Finish to close the Wizard.
9. Click Yes to restart the system. (Remove the CD-ROM).
10. After the system reboots, login to the system.
11. Open Start | Settings | Control Panel | Administrative Tools. Check that
the following services are now available: "Terminal Services
Client Creator", "Terminal Services Configuration" and
"Terminal Services Manager".
Create Client Installation Diskettes
1. Double click Terminal Services Client Creator.
2. Select the appropriate client type for your environment.
3. Click Format disk if needed. Check the number of disks required and label
them as "Terminal Services for [..] Disk [x/y]". Click OK to proceed.
4. Follow on-screen instructions to perform the diskettes copies.
5. Click OK at the screen that reads "[y] floppies were created....".
6. Click Cancel to end the "Create Installation disks" utility.
22
The following instructions are based on the Application
server mode. Please note the licensing requirement listed
on the screen for this mode. Consult with your Microsoft
representative for setting the licensing server.