Section 2. Create Microsoft Windows Nt Installation Diskettes; Section 3. Perform Windows Nt Installation - HP Tc2100 - Server - 128 MB RAM Installation Manual

Chapter 2
NOTE If the Windows PC does not auto-start the Startup menu, start it
by opening Startup.htm found at the root level of the
Startup CD.
Section 2. Create Microsoft Windows NT
Installation Diskettes
Three installation diskettes are required to install Microsoft Windows NT 4.0 on
your server. Follow these steps to create these installation diskettes:
1. Locate three blank, formatted 3.5" diskettes.
2. Insert your Microsoft Windows NT 4.0 CD-ROM into a desktop PC.
3. From a DOS prompt, type:
C:\D:\i386\winnt32 /ox
(where D is the drive letter for the CD-ROM)
4. Follow the prompt and insert the diskettes in the order described.

Section 3. Perform Windows NT Installation

The installation of Windows NT contains several phases:
• Phase 1 – Driver(s) Installation
• Phase 2 – Hard Drive Preparation
• Phase 3 – System Configuration Details
• Phase 4 – Configuring the Network
• Phase 5 – Completing the Installation
• Phase 6 – Install the Service Pack
• Phase 7 – Install the HP Video Driver
NOTE
Do not try to install Windows NT 4.0 via booting from the
Windows NT CD-ROM. This method of installation does not
work properly on most servers. The installation procedure will
prompt you to insert the Windows NT CD-ROM at a later
time.
4
Installing Microsoft Windows NT 4.0 Server