Install Service Pack For All Hp Netservers - HP D5970A - NetServer - LCII Configuration Manual

Configuration Guide for your cluster. If you are using two HP D5013A/B NICs, load the driver
twice, once for the intra-cluster NIC and once for the client NIC.
Make sure TCP/IP Protocol is selected.
Other protocols may be selected in addition, but TCP/IP is required.
If you are using two HP D5013A/B NICs, when prompted for TCP/IP Properties:
Make sure adapter [2] is highlighted and specify its IP address and subnet mask. This will be the
LAN adapter for the intra-cluster LAN.
Select adapter [1] and specify its IP address and subnet mask. This will be the LAN adapter for the
client LAN.
Set TCP/IP Properties for DNS, WINS Address, etc. at this time.
NOTE
The Client LAN IP addresses and Intra-cluster LAN IP addresses must be on different
subnets.
4. Once the NT installation is complete, the D5013A/B NIC drivers must be manually set to the correct
LAN speed. Log on and from the start menu select: Settings, Control Panel, Network, and
Adapters. For each D5013A/B adapter, select Properties then Settings and set the network
speed to the appropriate setting (either 10 Mbps or 100 Mbps) for your network. The intra-cluster LAN
should be set to 100 Mbps. Do not use the Auto setting.
Part "6 Shared Storage Software Setup" in the Shared Storage Supplement and start with
Install Fibre Channel HBA Driver.

Install Service Pack for All HP NetServers

Refer to the Configuration Guide for your cluster configuration and install the applicable Microsoft Service
Pack. If using SP3 do not install the Hot Fix at this time.
NOTE
Do not install the Microsoft Cluster Server Software (MSCS) at this time.
NOTE
After completing these procedures, power down System B and power up System A.
Repeat all of the procedures in this part for System A.
For Fibre Channel solutions using the Rack Storage/12FC simply reboot System B and
repeat the procedures on Systems A. Both systems can be powered up.
HP NetServer Installation Guide
35