Installing The Antenna (Wireless Models); Installing The Rubber Feet; Installing The Stand - HP st5747 - Streaming Client Hardware Reference Manual
Streaming thin clients
Hide thumbs
Also See for st5747 - Streaming Client:
- Quick setup and getting started manual (56 pages) ,
- Troubleshooting manual (53 pages) ,
- Support telephone numbers (19 pages)
Table of Contents
Advertisement
Installing the Antenna (Wireless Models)
Screw the antenna in place on the rear of the thin client.
▲
Figure 1-5
CAUTION:
Installing the Rubber Feet
To install the rubber feet:
1.
Lay the thin client on its right side.
2.
Remove the feet from their backing.
3.
Press each foot down securely onto a corner of the left side of the thin client.
Figure 1-6
Installing the Stand
If the thin client will be installed in an vertical orientation and it will not be mounted, the stand should be
installed for stability.
ENWW
Installing the antenna
To prevent damage to the antenna mounting, do not overtighten the antenna.
Installing the rubber feet
Installing the Antenna (Wireless Models)
5
Advertisement
Table of Contents
Need help?
Do you have a question about the st5747 - Streaming Client and is the answer not in the manual?
Questions and answers