HP st5747 - Streaming Client Hardware Reference Manual page 27

2. Remove the access plate:
Figure 2-10
a. Remove the two screws securing the access plate to the chassis.
b. Lift the rear edge of the plate and pull the plate back and up off the chassis.
3. Hold the SO-DIMM at about a 20–degree angle and insert the SO-DIMM into the socket.
NOTE:
the tab on the memory socket.
Figure 2-11
4. Push the module into the socket, ensuring that the module is fully inserted and properly seated.
5. Press the module down into the compartment.
ENWW
Removing the SO-DIMM access plate
A memory module can be installed in only one way. Match the notch on the module with
Installing a SO-DIMM
Installing Thin Client Options 21