HP Brio 80xx Upgrade Manual page 57

2 Gently place the processor in the socket.
3 Lower the socket's lever to lock the processor into position.
4 Replace the heatsink and fasten the clip (if the heatsink is not directly attached to the processor).
Caution
5 If there is a fan mounted on the heatsink of the processor, connect the fan to the processor fan connector on the system
board (the connector is shaped to go in one way only). The front bezel fan should also be connected.
Setting the System
Set the system board configuration jumpers.
Board for the
The following diagram shows the location on the system board of the jumpers used to configure the computer for the
Processor Type
new processor.
If any thermal interface material, such as aluminum foil or silicone, is supplied with the heatsink or the processor,
place it carefully on the top of the processor before installing the heatsink.
Processor
Processor Fan
Connector
System Board
Front Bezel
Fan Connector
2 Installing Accessories in Your Computer
Installing a Processor Upgrade
57