HP Brio 80xx Upgrade Manual page 38

12 Install any other accessories before replacing the cover and reconnecting the power cords and any telecommunications
cables. Turn on the display and computer.
13 If you have just installed a Plug and Play expansion card, Windows 95 is able to recognize and configure the card
automatically. The New Hardware Found dialog box is displayed while Windows 95 loads the necessary driver(s).
If you have just installed a non-Plug and Play expansion card, run the Windows 95 Add New Hardware wizard
(accessible from the Windows 95 START | Settings | Control Panel) to help Windows 95 to recognize and
configure the card.
Troubleshooting
If the new card is not recognized, check that you have correctly followed the installation procedure described above.
If there are any errors reported during the computer's startup routine, press
necessary action.
If you find that files on your storage devices no longer correspond to the correct drive letter (for example the content
of disk C is now shown as being on disk E), you have reversed the connection of the primary and secondary IDE cables
on the system board. Remove the computer's cover (refer to
connection of the IDE cable as shown below.
If you cannot start your computer properly, remove the card and try starting your computer again. If the computer now
starts OK, there may be a problem with the new card.
If you experience any other problems as a result of the upgrade, refer to the online support center.
CD-ROM
HDD
FDD
System Board
to view the error(s) and take any
"Removing the Cover" on page
Secondary IDE Connector
Disks E and F Reverse the cable connection
Primary IDE Connector to these two connectors
Disks C and D
Floppy disk Connector
Disks A and B
2 Installing Accessories in Your Computer
Installing Expansion Cards
23) and reverse the
38