HP Brio 80xx Upgrade Manual page 48

The following table explains which connectors you should typically use when you install additional IDE devices.
Type of Storage
Device
One to four hard 1. Bootable hard disk drive:
disk drives
2. Second hard disk drive:
3. Third hard disk drive (not available if a CD-ROM drive is installed):
4. Fourth hard disk drive (not available if a Zip drive is installed):
One CD-ROM drive 1. CD-ROM drive (not available if the third hard disk drive is installed—see above):
One or two floppy 1. Primary floppy disk drive:
disk drives
2. Second floppy disk drive (not available if the tape drive is installed):
One tape drive 1. Primary tape drive (not available if the second floppy disk drive is installed—see above):
One Zip drive 1. Zip drive (not available if the fourth hard drive is installed—see above):
If you install a hard disk drive and connect it to the cable that the CD-ROM drive is connected to, the hard disk drive
Note
must be connected to the first connector in the cable from the system board, not the last connector. If you have a
CD-ROM drive currently connected to the first connector, you must reconnect the CD-ROM drive to the last
connector of the cable, and then attach the new hard disk drive to the first connector.
Connections to Data Cables
Device
2 Installing Accessories in Your Computer
Installing Storage Devices
Connection
Primary IDE cable, drive C connector
Primary IDE cable, drive D connector
Primary IDE cable, drive E connector
Secondary IDE cable, drive F connector
Secondary IDE cable, drive E connector
Floppy disk cable, drive A connector
Floppy disk cable, drive B connector
Floppy disk cable, drive B connector
Secondary IDE cable, drive F connector
48