Cleandrv.exe; Convdate; Creatsp - Lenovo ThinkCentre A62 Deployment Manual

1. Retrieve value of UUID and Index. You can get the value of UUID and Index of
2. Select your backup to restore. For example, the command below is to restore

CLEANDRV.EXE

The cleandrv.exe file cleans all files on the drive. There will be no operating system
after running this command. See "Scenario 6 - Performing a Bare Metal Restore
from an Admin Backup" on page 58 for more information.

CONVDATE

The CONVDATE utility is provided as part of the Rescue and Recovery
Administration tools. This utility is used to determine the HEX values of date and
time and to convert date and time values into HEX values, and can be used to set
a custom date and time in a backup field of the registry.
[Backup0]
StartTimeLow=0xD5D53A20
StartTimeHigh=0x01C51F46
To run the CONVDATE utility, complete the following steps:
1. Extract the Rescue and Recovery Administration tools from:
2. Open a CMD window.
3. Type in Convdate.
4. Set the date and time in the convdate window.

CREATSP

This command creates a partition for Service Partition by desired megabytes. The
drive letter is optional.
The syntax is:
createsp size=x drive=x /y
The parameters for CREATSP are:
64
Rescue and Recovery 4.3 Deployment Guide
the backups stored in the USB storage device, by executing either of the
following commands:
v
rrcmd listsystem location=U
v
rrcmd listsystem location=U listbackup
the first backup (index=1) that is level=2:
rrcmd restore location=U index=1 level=2
http://www.lenovo.com/support/site.wss/document.do?lndocid=TVAN-
ADMIN#rnr
Note: The corresponding registry file values are:
v High DWORD=StartTimeHigh
v Low DWORD=StartTimeLow
Table 24.
Parameters
size=x
drive=x
Description
Size of service partition to create, in
megabytes.
The drive number to create the service
partition on. If not specified, the first
non-USB drive is used. This parameter is
optional.