Lenovo ThinkCentre A62 Deployment Manual page 70

62
Rescue and Recovery 4.3 Deployment Guide
Table 23. RRcmd parameters (continued)
Command Result
List files that are included in the backup level (must include
List
location and level).
Initiate an alternative base backup. This is not to be used as a
Basebackup
basis for incremental backups, and must include the location,
name and level. The level must be less than 99. If another base
backup with the same level already exists, it will be overwritten.
Sysprepbackup Stage a backup operation in the Pre Desktop Area after the
computer is rebooted. The primary use for this feature is to
capture a Sysprep backup.
Notes:
1. In some cases, the progress bar does not move. If this occurs,
2. Sysprepbackup in Windows 7 is not allowed to be copied after
Copy backups from one location to another. This command is also
Copy
known as archive and must include the location.
Rejuvenate operating system to the specified backup.
Rejuvenate
Delete backups. This command must include the location.
Delete
Change files in all backups based on file.txt contents. Options in
Changebase
file.txt are:
A Add
D Delete
R Replace
Files and folders that will be restored. This command is used only
Filter=filterfile
with the Restore command.
One or more of the following can be selected with the associated
Location=c
result:
L For primary local hard drive
U For USB hard drive
S For second local hard drive
N For network
C For CD/DVD Restore
Where abc, is the name of the backup.
name=abc
you can verify the backup is occurring by listening to the hard
disk drive. When the backup is complete, you will receive a
message that the backup is complete.
it is made; otherwise, it will cause problems when restoring the
backup because the related REGISTRY values have not been
set. It is recommended to create the Sysprepbackup directly to
the external media location.