Lenovo ThinkCentre A62 Deployment Manual page 19

v Russian
v Spanish
v Swedish
v Simplified Chinese
v Traditional Chinese
Rescue and Recovery custom public properties
The installation package for the Rescue and Recovery program contains a set of
custom public properties that can be set on the command line when running the
installation. The available custom public properties are:
Table 3.
Property
PDA
CIMPROVIDER
EMULATIONMODE
HALTIFTPMDISABLED
ENABLETPM
SUPERVISORPW
Including the Rescue and Recovery program in a disk image
You can create a disk image that includes the Rescue and Recovery program. This
deployment guide takes PowerQuest and Ghost as examples.
Note: If you plan to create an image, you must capture the Master Boot Record.
The Master Boot Record is critical for the Rescue and Recovery environment to
function correctly.
Description
Specifies whether to install the Predesktop
Area. Default value is 1. 1 = install
Predesktop Area. 0 = do not install
Predesktop Area. NOTE: This setting is not
used if any version of the Predesktop Area
already exists.
Specifies whether to install the Common
Information Model (CIM) Provider
component. Default is to not install the
component. Specify CIMPROIVIDER=1 on
the command line to install the component.
Specifies to force the installation in
Emulation mode even if a Trusted Platform
Module (TPM) exists. Set
EMULATIONMODE=1 on the command line
to install in Emulation mode.
If the TPM is in a disabled state and the
installation is running in silent mode, the
default is for the installation to proceed in
emulation mode. Use the
HALTIFTPMDISABLED=1 property when
running the installation in silent mode to
halt the installation if the TPM is disabled.
Set ENABLETPM=0 on the command line to
prevent the installation from enabling the
TPM
Set SUPERVISORPW="password" on the
command line to supply the supervisor
password to enable the chip in silent or
non-silent installation mode. If the chip is
disabled and the installation is running in
silent mode, the correct supervisor password
must be supplied to enable the chip,
otherwise the chip is not enabled.
Chapter 2. Installation
11