Step 3: Charge The Battery; Step 4: Turn On Your Hp Ipaq; Find The Serial And Model Number - HP iPAQ 610 - Business Navigator Product Manual

Step 3: Charge the battery

CAUTION:
aligned before connecting.
The battery provides power for your HP iPAQ to operate. Use the mini-USB synchronization cable, that
comes with your HP iPAQ, to charge the device.
It takes approximately 2-4 hours to fully charge the battery for the first time. Subsequent charges might
take longer.
To charge the battery:
1. Insert the USB end of the mini-USB synchronization cable into the port on the AC adapter.
2. Connect the AC adapter to an electrical outlet.
3. Connect the mini-USB synchronization cable to the charging/communications port on your
HP iPAQ. The cable connector only fits one way. If the connector does not insert easily, turn it over.
TIP: You can also charge the battery by connecting your HP iPAQ to a USB port on your computer
using the mini-USB synchronization cable. To enable USB charging on your iPAQ, tap Start >
Settings > System > Power > USB Charging. On the Power screen, select the Use USB
Charging check box.
NOTE:
at least two seconds. In case the device does not turn on, attach an AC adapter to turn on your
HP iPAQ.

Step 4: Turn on your HP iPAQ

Press and hold the Power key for a few seconds to turn on your HP iPAQ. Next, follow the instructions
on the screen to complete the setup. Use the on-screen keypad to enter information.
NOTE: The HP iPAQ will take a few minutes for the initial boot up. The keypad will not be active during
this period.

Find the serial and model number

Locate the serial and model numbers before contacting HP Customer Support, particularly if you are
calling for in-warranty support.
View the serial and model number by tapping Start > Programs > HP Help and Support > Serial and
Model Number.
To avoid damaging your HP iPAQ or the AC adapter, make sure all connectors are properly
Whenever a replacement battery is inserted into your HP iPAQ, press the Power key for
Step 3: Charge the battery 9