Step 2: Charge The Battery; Step 3: Insert The Getting Started Cd Into The Cd Drive Of Your Personal Computer - HP iPAQ rx4200 - Mobile Media Companion Product Information Manual

Step 2: Charge the battery

CAUTION To avoid damaging your HP iPAQ or the AC adapter, be
sure all connectors are properly aligned before connecting.
The battery provides power for your HP iPAQ to operate. Your HP iPAQ
comes with a mini-USB synchronization cable, which must be used to charge
the device.
It takes approximately 2 to 4 hours to fully charge the battery the first time.
Subsequent charges may take longer.
1. Insert the USB end of the mini-USB cable into the port on the AC adapter.
2. Install the appropriate head onto the AC adapter.
3. Connect the AC adapter to an electrical outlet.
4. Connect the mini-USB cable to the charging/communications port on
your HP iPAQ. The cable connector only fits one way, so do not force it.
If the connector does not insert easily, turn it over.
Step 3: Insert the Getting Started CD into the CD drive of your
personal computer
Use the Getting Started CD to complete the setup of your HP iPAQ and to
synchronize the HP iPAQ with your personal computer.
The HP Install Wizard automatically opens, and the application starts to run.
NOTE Do you have administrative rights on your personal
computer? If not, you may have problems installing the applications
from the Getting Started CD. The administrator needs to install the
applications.
ENWW Setting Up Your HP iPAQ 9