Kyocera KM-4800w User Manual page 42

<Cut Mode>
Select cut mode of paper
Check
No check
<Mirror>
Setting of mirror
<Negative Image>
A mirror image can be printed
<Density>
Set Image Density
When input value is smaller, it shows lighter image, and vice versa.
1 - 9
<Image Shift>
Set if Image is required to shift from the center.
When "Set" button is clicked, the following dialog is popped up.
Image placement is selectable up-shown 9 location.
When fine adjustment of the location is necessary, put the value to move to Offset
X and Y.
When X is set as a positive, it moves to right. (-500 to 500)
When X is set as a negative, it moves to left. (-500 to 500)
When Y is set as a positive, it moves to upper. (-500 to 500)
When Y is set as a negative, it moves to lower. (-500 to 500)
Note: If some of the above items are modified, click [Enter] button, and
register the configuration.
Standard Cut
Synchronized Cut
41