Installing Expansion Memory (Optional) - Kyocera Mita FS-C5016N - Color LED Printer Service Manual

1-3-2 Installing expansion memory (optional)

<Procedure>
1. Turn off printer power.
* Caution: Do not insert or remove expan-
sion memory while printer power is on.
Doing so may cause damage to the printer
and the expansion memory.
2. If a memory card is currently installed in the
memory card slot (See the figure), remove
the memory card first.
3. Remove two screws and then remove the
main controller PWB.
4. Open the stoppers of the memory socket.
5. Insert the memory so that the two notches
of the memory are engaged with the projec-
tions of the memory socket.
6. Close the stoppers of the memory socket.
7. Reattach the main controller PWB in the
printer.
8. Print a status page to check the memory
expansion.
* If memory expansion has been properly per-
formed, information on the installed memory
is printed with the total memory capacity has
been increased. Standard memory capacity
96 MB.)
Memory card slot
Figure 1-3-12
Stopper
Memory socket
Figure 1-3-13
FS-C5016N
Screw
Main controller PWB
Screw
Memory
(DIMM)
Stopper
1-3-7