Solving Printing Problems; Jobs Do Not Print - Lexmark 34S0109 - E 260dt B/W Laser Printer User Manual

Solving printing problems

Jobs do not print

These are possible solutions. Try one or more of the following:
M
AKE SURE THE PRINTER IS READY TO PRINT
Make sure the light is on before sending a job to print.
C
HECK TO SEE IF THE STANDARD EXIT BIN IS FULL
Remove the stack of paper from the standard exit bin.
C
HECK TO SEE IF THE TRAY IS EMPTY
Load paper in the tray.
M
AKE SURE THE CORRECT PRINTER SOFTWARE IS INSTALLED
Verify that you installed the correct printer software for your printer model.
Click Install printer and software on the Software and Documentation CD to check which software is installed. Make
sure the model number of the software matches the model number of your printer.
To verify that the printer software is the most current, check the Lexmark Web site at www.lexmark.com.
M
AKE SURE THE PRINTER IS CONNECTED TO THE NETWORK
Print a network setup page and check that the status shows Connected. If the status is Not Connected, check the
network cables, and then try printing the network setup page again. Contact your system support person to make
sure the network is functioning correctly.
Copies of the printer software are also available on the Lexmark Web site at www.lexmark.com.
M
AKE SURE YOU ARE USING A RECOMMENDED
For more information, visit the Lexmark Web site at www.lexmark.com.
M
AKE SURE PRINTER CABLES ARE SECURELY CONNECTED
Check the cable connections to the printer to make sure they are secure. For more information, see the setup
documentation that came with the printer.
USB, , E
PARALLEL OR
Troubleshooting
110
THERNET CABLE