Table of Contents
Advertisement
5. In printer driver properties, set the necessary options.
•
For PS driver, select the Installable Options section and set the
necessary options.
6. Click OK.
UPGRADING A MEMORY MODULE
Your machine has a dual in-line memory module (DIMM). Use this memory
module slot to install additional memory.
The machine has two memory slots with a factory pre-installed memory
module in one slot. When you are expanding the memory capacity, you can
add a memory module to the vacant memory slot. It is strongly
recommended that you expand a memory module in the vacant memory
slot, and not by removing a pre-installed memory module. If your machine
has 64 MB memory capacity and you want to add 128 MB, the memory
capacity expands up to 192 MB. Order information is provided for additional
memory module. (See "Available accessories" on page 77.)
Installing a memory module
1. Turn the machine off and unplug all cables from the machine.
2. Grasp the control board cover and remove it.
3. Remove the new memory module from its bag.
4. Holding the memory module by the edges, align the memory module on
the slot at about a 30-degree tilt. Make sure that the notches of the
module and the grooves on the slot fit each other.
The notches and grooves illustrated above may not match those
on an actual memory module and its slot.
5. Press the memory module into the slot with care until you hear a 'click'.
Do not press the memory module strongly or the module may be
damaged. If the module does not seem to fit into the slot properly,
carefully try the previous procedure again.
6. Replace the control board cover.
7. Reconnect the power cord and machine cable and turn the machine on.
If you use the PS driver, you must activate the added memory in the
PS driver properties.
Supplies and accessories_ 79
Advertisement
Table of Contents
