Table of Contents
Advertisement
network setup
3.
This chapter gives you step-by-step instructions for setting up the network connected machine and software.
This chapter includes:
•
Network environment
•
Introducing useful network programs
NETWORK ENVIRONMENT
You can use network after connecting network cable to a corresponding
port on your machine.
You need to set up the network protocols on the machine to use it as your
network machine. You can set up the basic network settings through the
machine's control panel.
The following table shows the network environments supported by the
machine:
ITEM
Network interface
Ethernet 10/100 Base-TX
Network operating system
•
•
•
Network protocols
•
•
•
•
•
If you want to setup DHCP network protocol, go to the
http://developer.apple.com/networking/bonjour/download/, select the
program Bonjour for Windows due to your computer operating system,
and install the program. This program will allow you to fix the network
parameter automatically. Follow the instruction in the installation
window. This program does not support Linux.
INTRODUCING USEFUL NETWORK PROGRAMS
There are several programs available to setup the network settings easily in
network environment. For the network administrator especially, managing
several machines on the network is possible.
SyncThru™ Web Service
Web server embedded on your network print server, which allows you to:
•
Configure the network parameters necessary for the machine to connect
REQUIREMENTS
Windows 2000/XP/2003/Vista
Various Linux OS
Mac OS 8.6~9.2, Mac OS X 10.1 ~ 10.5
TCP/IP on Windows
IPP
DHCP
SNMP
BOOTP
•
Configuring TCP/IP
•
Installing network connected machine's driver
to various network environments.
•
Customize machine settings.
(See "Using SyncThru™ Web Service" on page 56.)
SyncThru™ Web Admin Service
Web-based machine management solution for network administrators.
SyncThru™ Web Admin Service provides you with an efficient way of
managing network devices and lets you remotely monitor and troubleshoot
network machines from any site with corporate internet access. Download
this program from http://solution.samsungprinter.com.
SetIP
This utility program allows you to select a network interface and manually
configure the IP addresses for use with the TCP/IP protocol. (See "Using
SetIP program" on page 57.)
CONFIGURING TCP/IP
When you connect your machine to a network, you must first configure the
TCP/IP settings for the machine. After you have assigned and verified the
TCP/IP settings, you are ready to install the software on each computer on
the network.
Setting the network address
Contact the network administrator if you are not sure how to configure.
You can set up TCP/IP network parameters, follow the steps below:
1. Make sure your machine is connected to the network with an RJ-45
Ethernet cable.
2. Make sure you have turned on the machine.
3. Press the
line of the display and press OK.
4. Press the left/right arrow until TCP/IP appears and press OK.
5. Press the left/right arrow until Static appears and press OK.
6. Set the first byte between 0 and 255 using the left/right arrow and press
OK.
Repeat this to complete the address from the 1st byte to the 4th byte.
If you press and hold one of the left/right arrows, the digits chnage
in units of ten.
7. When you have finished, press OK.
Repeat step 6 and 7 to configure the other TCP/IP parameters: subnet
mask and gateway address.
Network setup_ 31
on the control panel until Network appears on the bottom
Advertisement
Table of Contents
