Table of Contents
Advertisement
1-4 Setting the Memory Switches
This printer has "Memory Switch" set which is software switches. Memory Switch set has
"MSW1", "MSW2", "MSW8", "MSW9" "Customize value", "Serial communication condition".
"Memory Switch setting utility" can change the Memory Switch set to ON or OFF as shown
in the table below. (default : all OFF)
※ NOTE
The Memory Switch is available to be changed by three methods.
- Memory Switch setting utility.
- Control from ESC/POS command.
Settings of the Memory Switch are stored in the NV memory : therefore, even if the printer
is turned off, the settings are maintained.
MSW1
Switch
Function
1~8
Reserved
MSW2
Switch
Function
1
Font Selection
2
Auto Cutter Function
3~8
Code Page Selection
Rev. 1.02
ON
--
ON
Font B (9 x 24)
Full Cutting
Refer to following Table
- 12 -
SRP-350plusF
OFF
Fixed to OFF
OFF
Font A (12 x 24)
Partial Cutting
Advertisement
Table of Contents
