Installing A Printer Memory Card - Lexmark 26H0122 - T 430d B/W Laser Printer Setup Manual

Installing a printer memory card

Warning:
Memory cards are easily damaged by static
electricity. Touch something metal on the printer before
you touch a card.
Notch
Latch
Notch
Install printer memory or firmware cards
19
Follow the instructions in this section to
install a printer memory card. Memory
cards must have 100-pin connectors.
1
Unpack the memory card.
Avoid touching the connection
points along the edge of the card.
Save the packaging.
2
Push open the latches on both
sides of the memory connector.
3
Align the notches on the card with
the notches on the connector.
4
Push the memory card firmly into
the connector until the latches on
both ends of the connector snap
into place.
It may require some force to fully
seat the card.
Make sure each latch fits over the
notch on the end of the card.
5
If you have a firmware card to
install, continue with "Installing a
firmware card" on page 20.
Otherwise, go to "Reattaching the
shield and side cover" on page 21.