Reattaching The Shield And Side Cover - Lexmark 26H0122 - T 430d B/W Laser Printer Setup Manual

Reattaching the shield and side
cover
Install printer memory or firmware cards
21
After installing memory or firmware
cards, you must reattach the shield and
side cover.
1
Align the five keyholes on the
shield with the five screws on the
system board.
2
Press the shield against the
system board, and then slide the
shield to the right.
3
Tighten the five screws.
4
Align the three rear tabs on the
side cover with the corresponding
slots on the printer.
5
Guide the tabs on the top, bottom,
and front of the cover into their
corresponding slots.
The top and front tabs snap into
place.
6
Close the upper front door and the
multipurpose feeder door.
Make sure both doors snap closed
on both sides.