Xerox Document Centre 460 Quick Install Manual page 25

WINS (Windows Internet Name Service) Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
Your Document Centre now has DHCP, LPR,
and NetBIOS over the IP protocol enabled by
default. If your DHCP server will provide host
name, IP address, Gateway address, and Sub-
net Mask, the Document Centre TCP/IP infor-
mation will be configured on initial boot.
This means that if you have configured your
DHCP server with the desired information, you
may connect your Document Centre to your net-
work and it will boot and register with the WINS
server automatically.
In this mode the default host name for the device
will be the letters XRX followed by the MAC
address of the network interface. Example:
XRX08003E313E0A
If this host name is acceptable you can go right
to the section on this card entitled Go to the
Workstation and.... and complete those steps.
To change the host name for your printer follow
Steps 1,2, and 3 then skip to Step 5 and finish
the Go to the Printer... portion. When you finish
that section, go to the section on this card
entitled Go to the Workstation and.... and
complete those steps.
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
Go to the printer and...
1.
Connect your Document Centre to the
network with the appropriate cabling
2.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the Microsoft Networks button.
4.
Enable the Transport and Media
a)
Press the Transport and Media
button.
b)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
5.
Set the NetBIOS Host Name
Page 1
a)
Press the Workgroup and Host
button.
b)
Press the SMB Host Name button.
c)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes.
d)
Press the Exit Tools button.
e)
The Document Centre will reconfigure
itself with the new settings and
automatically register its TCP/IP
address and NetBIOS host name with
your WINS server.
Go to the workstation and...
1.
Create a new lpr printer on the NT
workstation
a)
With an LPR port as the desired
destination, enter the Microsoft
Networking host name.
b)
Enter a queue name to identify the
printer.
c)
When prompted, select the desired
PostSricpt or PCL driver from the
CentreWare Network Services CD or
a directory where drivers are stored.