Xerox Document Centre 460 Quick Install Manual page 19

Microsoft Windows NT 4.0 Server (TCP/IP) Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card.
Your Document Centre has DHCP enabled by
default. If you have configured a DHCP server
with TCP/IP information, you can connect your
Document Centre to your network and it will
retrieve its TCP/IP information from the DHCP
server when it is turned on.
You can manually assign or use BOOTP or
RARP servers to assign TCP/IP information to
your Document Centre. Refer to the Static,
DHCP/BOOTP, and RARP Quick Install Cards
for details.
If you are using DHCP, perform Steps 1
through 6c but DO NOT change any values.
Then read the note before step 6d and
determine if you wish to change the lpr port
number. After choosing, complete the
remainder of the procedure.
Record the following information:
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
Go to the printer and...
1.
Connect your Document Centre to the
network with the appropriate cabling
2.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
Page 1
4.
Enable the Protocol and Media
a)
Press the TCP/IP Settings button.
b)
Press the Protocol and Media button.
c)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
NOTE: The Broadcast Address will be calcu-
lated automatically.
5.
Set the Host Name
a)
Press the Name/Address button.
b)
One at a time press the soft buttons on
the Touch Screen for each octet of the
IP address and enter the numbers
using the keypad.
c)
Press the Host Name button.
d)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.