Xerox Document Centre 460 Quick Install Manual page 15

UNIX (Solaris/SunOS) (HP-UX)(AIX) Quick Install Card
Xerox Document Centre 460/470 ST
Before You Start
To enable 100BaseT or a Token Ring interface,
refer to the 100BaseT Ethernet and Token
Ring Interface Quick Install Card to configure
the Speed and Source Routing settings for your
environment. Then return to this card and
perform the procedure here.
NOTE: By default, DHCP is enabled on the
Document Centre. This card will show you
how to disable DHCP and manually set your
TCP/IP information.
You can use BOOTP or RARP servers to assign
TCP/IP information to your Document Centre.
Refer to the RARP or BOOTP Quick Install
Cards for details.
Record the following information on this card for
use during the procedure:
IP Address ____________________________
Subnet Mask ___________________________
Default Gateway ________________________
Your Document Centre printer supports printing
from a variety of UNIX platforms.
Go to the printer and...
1.
Connect your Document Centre to the net-
work with the appropriate cabling.
2.
Enter the Tools pathway.
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
3.
Enter the Network Setup menus.
a)
Wait for the screen to refresh and
press the Connectivity and Network
Setup button.
b)
Wait for the screen to refresh and
press the Network Setup button.
c)
Press the TCP/IP Options button.
Page 1
4.
Enable the network interface and protocol.
a)
Press the TCP/IP Settings button.
b)
Press Dynamic Addressing.
c)
Press Disabled then press Save.
d)
Press the Protocol and Media button.
e)
Press the Enable button. If Physical
Media buttons appear, select either
Ethernet or Token Ring. Press Save.
NOTE: The Broadcast Address will be calcu-
lated automatically.
5.
Set the Host Name.
a)
Press the Name/Address button.
b)
One at a time press the soft buttons on
the Touch Screen for each octet of the
IP address and enter the numbers
from the keypad.
c)
Press the Host Name button.
d)
When the soft keypad appears, type
the host name EXACTLY as you want
it to appear with correct case. When
finished press the Save button to
record the changes and exit to the
TCP/IP Settings Screen.