Wired Remote Control Operation; Remote Control Batteries Installation - Eiki LC-VC1 Owner's Manual

When using this Remote Control Unit as Wired Remote Control, Connect Remote Control Unit to R/C JACK with Remote Control Cable
(supplied). Batteries installation is required when using as Wired Remote Control Unit.
1.
Remove the battery compartment
lid
To insure safe operation, please observe the following precautions:
•Use (2) AA, UM3 or R06 type alkaline batteries.
•Replace two batteries at the same time.
•Do not use a new battery with a used battery.
•Avoid contact with water or liquid.
•Do not expose Remote Control Unit to moisture, or heat
•Do not drop Remote Control Unit.
•If batteries have leaked on Remote Control Unit, carefully wipe the case clean and load new batteries..
WIRED REMOTE CONTROL

REMOTE CONTROL BATTERIES INSTALLATION

2
Slide 2 batteries into the compartment.
OPERATIONS
3
Replace the compartment lid.