Attaching The Leveling Feet And Leveling The Cabinet; Installing The Front Door Bezels And The Front And Back Blower Bezels - HP Integrity Superdome SX1000 User Manual

Step 5. Repeat Step 1 through Step 4 for the skins on the other side of the cabinet.
Step 6. To secure the side bezels to the side skins, attach the blower bracket locks (Hewlett-Packard P/N
A5201-00268) to the front and back blowers using a T20 Torx driver.
There are two blower bracket locks on the front blowers and two on the rear. Refer to Figure 2-19.

Attaching the Leveling Feet and Leveling the cabinet

After positioning the cabinet to its final position, attach and adjust the leveling feet using the following
procedure:
Step 1. Remove the leveling feet from their packages.
Step 2. Attach the leveling feet to the cabinet using four (T25 Torx) screws.
Figure 2-20Attaching the Leveling Feet
Step 3. Screw down each leveling foot clockwise, until it is in firm contact with the floor. Adjust each foot
until the cabinet is level.

Installing the Front Door Bezels and the Front and Back Blower Bezels

There are two doors: one at the front and one at the back. The back door is shipped on the chassis and
requires no assembly. The front door, which is also shipped on the chassis, requires the assembly of two
plastic bezels to its front surface and a cable from the door to the upper front bezel. In addition, there are
bezels that fit over the blowers at the front and back of the cabinet.
Installing the Front Door Bezels
The front door assembly includes two cosmetic covers, a control panel, and a key lock. Installing the front door
is a three-step process: connecting the control panel ribbon cable from the chassis to the control panel, and
mounting the two plastic bezels onto the metal chassis door.
Chapter 2
Setting Up the hp Integrity Superdome or hp 9000 Superdome
Installing the System
43