Removing The Rear Blower Bezel; Replacing The Rear Blower Bezel - HP Integrity Superdome SX1000 User Manual

Removing and Replacing Components
Removing and Replacing the Rear Blower Bezel

Removing the Rear Blower Bezel

Figure 3-24 Rear Blower Bezel Detail
Step 1. Loosen the two captive T-20 screws on the lower flange of the bezel.
Step 2. Lift the bezel up and off of the blower housing frame.
Step 3. Place bezel in a location where it will not be damaged.

Replacing the Rear Blower Bezel

Step 1. Slide the bezel over the blower housing frame, hooking the lip of the bezel onto the cross support of
the blower housing.
Step 2. Tighten the two captive screws on the lower flange of the bezel.
111
Chapter 3