Setting Customer Ip Address - HP Integrity Superdome SX1000 User Manual

Installing the System
Connecting the MP to the Customer LAN

Setting Customer IP Address

NOTE The default IP address for the Customer LAN port on the MP is 192.168.1.1.
To set the customer LAN IP address:
Step 1. From the MP Command Menu prompt (MP:CM>), enter lc (for LAN Configuration).
The screen displays the default values and asks if you want to modify them. It is a good idea to
write down the information, as it may be required for future troubleshooting.
If you are not already in the Command Menu, enter ma to return to the Main Menu, then enter cm
When you enter lc, the following screen appears:
Figure 2-35LAN Configuration Screen
If the LAN software on the MP is working properly, it should see the message: "LAN status: UP and
RUNNING." The value in the "IP address" field has been set at the factory. You will need to get the
customer LAN IP addresses from the customer.
NOTE
Step 2. The prompt will ask if you want to modify the LAN port 0; enter y.
The current Customer IP address is shown; then the following prompt appears: Do you want to
modify it? (Y/[N])
Step 3. Enter y.
Step 4. Enter the new IP address.
The customer should provide this address for LAN Port 0.
Step 5. Confirm the new address.
Step 6. Enter the MP Network Name.
58
The customer LAN IP address is designated LAN Port 0.
Chapter 2