Figure 2-42MP Virtual Front Panel
Step 6. From the VFP menu, enter s to select the whole system or the partition number to select a
particular partition. An output similar to that shown in Figure 2-43 should appear. In this example,
no status should be listed, because the system 48 volts has not been switched on.
Figure 2-43Example of Partition State—Cabinet Not Powered Up
Step 7. For each of the remaining windows, bring up the partition console for each partition by enter co at
the MP prompt, as shown in Figure 2-44. These windows should be blank. If not, the information in
them means nothing at this point, because the cabinet is powered off.
Chapter 2
Installing the System
Booting and Verifying the System
65