Setting Up The Projector; Setting The Network Password; Setting The Mail Report - Sony VPL-TX70 Operating Instructions Manual

Setting up the
Projector
Setting the Network
Password
Click on "Network."
Click on "Network." The password entry
screen will appear. The name of the User
account is fixed without a password to "root"
at the factory.
When you finish logging in, enter the
information for the network settings.
Location
Enter the network location of the projector.
Obtain an IP address automatically
(DHCP): Select this to obtain an IP
address automatically.
Specify an IP address: Select this to specify
an IP address manually. Enter the
information to be filled in.
Click on "Apply." The setting will be
completed.
Notes
• If the IP address is changed, you will not be
able to access the network using the old IP
address. Reconnect using the specified IP
address of the projector.
• When DHCP is On on the SET SETTING
menu on the projector, you cannot specify a
new IP address. When DHCP is Off, you can
specify the IP address for connection.
Password
Enable: Select this to create a password.
Disable: If you select this, the entry screen
texts will be disabled.
Click on "Apply." The setting will be
completed.
Notes
• When you change the password, input a new
password after deleting the password
(*****) that was set.
• If you forget your password, consult
qualified Sony personnel.

Setting the Mail Report

Click on "Mail Report."
E-Mail Report
Enable: Select this to set the E-Mail Report.
Disable: If you selects this, the screen will
be disabled.
Send to/CC
Enter the e-mail addresses to which you
wish the e-mail messages to be sent in each
text box. The projector allows you to send e-
mail to two different addresses. You can
enter up to 64 characters for each address.
Report Timing
Over Lamp Usage Time: Check this check
box to arrange sending of the time for
replacement of the projector lamp.

Setting up the Projector

45