Projecting - Sony VPL-TX70 Operating Instructions Manual

Projecting

1,2 4 7
Front
remote
control
detector
INPUT NETWORK USB
4
MENU
ENTER
RESET
KEYSTONE
AUTO FOCUS LENS
/TILT
D ZOOM VOLUME FREEZE
1
Plug the AC power cord into a wall
outlet, and connect all equipment, then
remove the lens cover.
1
8
2
APA
7
7
PIC MUTING
AUDIO MUTING
The ?/1 key lights in red and the
projector goes into standby mode.
2
Press the ?/1 key.
The ?/1 key lights after flashing in
green. (The projector cannot be used
while the ?/1 key is flashing.)
3
Turn on the equipment connected to
the projector.
4
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
Input-A t Input-B t Video t S-Video
To input from
Computer/Component
connected to the INPUT
A connector
Computer connected to
the INPUT B connector
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the
S VIDEO input
connector
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
Notes
• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see "Auto Input Search"
on page 35.
• The Smart APA feature is effective for
the input analog signal from a computer
only.
Press INPUT
to display
Input-A
Input-B
Video
S-Video
21
Projecting