Connecting The Projector To A Local Network; Accessing The Projector From A Computer - Sony VPL-TX70 Operating Instructions Manual

Connecting the Projector to a
Local Network
Using a commercially available network
cable, connect the NETWORK connector on
the projector to a hub in the network.
Rear side
Hub
Network
NETWORK
Network cable
(straight, not supplied)
10BASE-T/
100BASE-TX
Accessing the
Projector from a
Computer
You can check the present status of the
projector on a computer display and control
the projector from a computer. Also, the
projector enables the sending of e-mail that
contains messages on the time for
replacement of the projector lamp, error
occurrences, etc., to e-mail addresses that
have been specified.
Before operating
Confirm that the projector is connected to
the LAN then turn on the projector. For
details on connection, consult your network
administrator.
1
Open Internet Explorer 5.0 (or later
version) on your computer.
2
Type "http://xxx.xxx.xxx.xxx (the IP
address of the projector)" as the
"Address" then press the ENTER key.
You can confirm the IP address of the
projector at "Network Setting" on the
SET SETTING menu. For details, see
"Setting the Network Setup on the
Projector" on page 46.
Note
When you access the projector via a Web
browser, do not use a proxy server.
Enter the IP address here.

Accessing the Projector from a Computer

43