Sony VPL-TX70 Operating Instructions Manual page 22

5
Switch the equipment connected to
output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys (e.g.,
/
,
LCD
VGA
your computer's settings.
F7
or
and
Fn
Note
The key used for switching the computer to
output to the projector varies depending on
the type of computer.
6
Adjust the upper or lower position of
the picture.
Use the adjuster to adjust the picture
position.
Using the adjuster
Lift the projector while pressing the
adjuster adjustment button, and adjust
the tilt of the projector, then release the
button to lock the adjuster.
Notes
• Be careful not to let the projector down
on your fingers.
• Do not push hard on the top of the
projector or do not drag it hard with the
adjuster out. It may cause malfunction.
22
Projecting
, etc.), or by changing
/
Fx
Adjuster adjustment button
7
Adjust the trapezoidal distortion
( ) of the picture.
Press the KEYSTONE key on the
Remote Commander to display the
adjustment menu and adjust the tilt using
the v/V/b/B keys.
For VPL-TX70
• When you adjust the tilt of the projector
with the adjuster, the V keystone
adjustment is performed at the same
time. If you do not want to perform the
automatic keystone adjustment, set the
"V Keystone" to "Manual." (See
page 38.)
• If you set the "V Keystone" to "Auto,"
the "V Keystone" correction is
automatically adjusted. However, it may
not be perfectly adjusted depending on
the room temperature or the screen
angle. In this case, adjust it manually.
Press the KEYSTONE key to "V
Keystone" displays on the screen, and
adjust the value with the v/V/b/B keys.
8
Adjust the size of the picture and the
focus.
Adjust the picture size using the Zoom
ring and adjust the picture focus using
the Focus ring.