Connecting The Projector; Connecting A Computer - Sony VPL-TX70 Operating Instructions Manual

Connecting the
Projector
When you connect the projector,
make sure to:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose
connections may increase noise and
reduce performance of picture signals.
When pulling out a cable, be sure to pull it
out by the plug, not the cable itself.

Connecting a Computer

This section describes how to connect the
projector to a computer.
For more information, refer to the
computer's instruction manual.
To connect a computer
Rear side
to monitor output
to audio input
1 HD D-sub 15-pin cable (supplied)
2 Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
Notes
• For stereo audio connection, connect the
stereo audio connecting cable to the AUDIO
INPUT connector.
• The projector accepts VGA, SVGA, XGA,
SXGA, SXGA+, WXGA signals. However,
we recommend that you set the output mode
of your computer to XGA mode for the
external monitor.
• If you set your computer, such as a notebook
computer, to output the signal to both your
computer's display and the external monitor,
the picture of the external monitor may not
appear properly. Set your computer to output
the signal to only the external monitor.

Connecting the Projector

Computer
19