Connecting The Projector; Connecting A Computer - Sony VPL-SW526C Operating Instructions Manual

B Preparation

Connecting the Projector

Notes
• Make sure all the equipment is powered off when connecting the projector.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or
cause a malfunction. When pulling out a cable, be sure to grip it by the plug, not the cable itself.
• For more information, refer also to the instruction manuals of the equipment you are connecting.
• Use a no-resistance audio cable.

Connecting a Computer

Connection with a computer is explained for each input signal.
INPUT A/INPUT B
For connecting a computer with an RGB output connector.
Computer
Note
It is recommended that you set the resolution of your computer to 1280 × 800 pixels (VPL-SW536C/
SW526C/SW536/SW526) or 1024 × 768 pixels (VPL-SX536) for the external monitor.
INPUT C
For connecting a computer with an HDMI output connector.
Computer
Notes
• Use HDMI-compatible equipment and cable(s) that have an HDMI logo on them.
• The HDMI connector of this projector is not compatible with DSD (Direct Stream Digital) Signal
or CEC (Consumer Electronics Control) Signal.
Mini D-sub 15-pin cable (not supplied)
RGB output
connector
Audio output
connector
Audio cable (Stereo mini plug)
(not supplied)
HDMI cable
(not supplied)
HDMI output
connector
Connecting the Projector
9